We added a new terminal block to the engine room. This is going to be for the bilge pump (Rule), bilge alarm and original bilge pump. Or so I think. It might not be big enough.
January 2011 - Currently At Marina Cortez Harbor Island, San Diego, CA
With this setup we can have the wires from the engine room going to the top terminals with a U-shaped solderless terminal end and the ones from the power source (nav station fuse block) going to the bottom terminals with a round solderless terminal ends because they will not be coming off. Then when we want to service the bilge pump like we just did as we had to replace the flapper, we can just back off the top screws and disconnect the wires. Then pull up the PVC pipe with the equipment on it. Much like the mast set up or the water pump etc.
New flapper.
No comments:
Post a Comment