Engine room clean up - hose replacements - 2011

We put the bilge pump hose in place. The new ¾ inch hose for the original bilge pump. It will be temporarily used with the Rule bilge pump till we re-build the old original one. You can see it hanging there the rubber re-enforced hose.
January - Currently At Marina Cortez Harbor Island, San Diego, CA 

We also bought the new 1 ¼ ID Rule bilge pump rubber re-enforced hose. This hose will go to the new through hole we bought and have yet to install. Darn engine installation is crowding the time out.
This is pricey hose but we do not trust that vacuum cleaner type bilge pump hose. I can collapse that hose with my fingers!
Also got some heater hose (Goodyear) from Marine Exchange 3/4 ID for the shaft vent. Decided while we were at it to replace that hose also!

No comments:

Post a Comment