Got some more propane locker work done.
Put a rim around the top of the box for a gasket. It is 1/2 inch plywood about 1 1/2 inches wide.
Also added a couple plywood pads for the top clamps and the propane regulator to sit on.
Replaced some extruding screws and now will add some plywood prices for the SS brackets to screw into for holding the propane locker(PL) to the boat.
I built a shelf for it to sit on. This way the PL will come out easily.
At this time I think the top will be sealed to the box by using hatch rubber for sealing and straps to hole the top down tight.
Remember propane sinks so this should work fine as long as the seal is good.
No comments:
Post a Comment