Refer insulation

 This week end we got to the boat on Saturday. We cleaned up a bit in the engine room. We took some odd and end measurements and went to lunch. We watched the sail boat races and had lunch with our daughter who stopped by. Then we went back to work on the refer. We got two more pieces of insulation cut and fit. No side is the same so it is not quick. There are no creature comforts on the boat at this time so it is a bit stark as comfort goes. There is no galley sink although it is no ready to go back in. No cushions in the settee or salon etc

 It is a real pain to cut the insulation because we measure it then close the lazzerett climb out to the dock and to the dock box, make a cut or how many and then climb back on board, me in the galley Debbie opens the lazzerett back up and try the fit. Needs another cut back we go etc sever times. So next time now that the baot has been straighten up a bit (no A frame and tools etc all over etc) we will bring down the work mate and place it in the cockpit and make the cuts right there. Hoping this will speed things up and no tire us out so much.

 These picture show only two of the three added pieces.