Refer insulation - foam

We got some more refer work done.
The wet looking area of wood is where Debbie epoxied to prevent moisture intrusion.

That wood section on the upper right is under the storage are behind the stove.


 We foamed the spaces around the Dow Blew board. 

This area is next to the stove looking up. It is under the storage area behind the stove where you put dishes etc. The light is one of the lights under the SS hood above the stove. 

This shot is next to the stove and the side of the port hull

Then when the foam was hard we trimmed off the excess and glued in a 2” thick bottom piece along the side of the hull. Of course there are angles on the bottom and top is longer than the bottom etc., nothing's just a square!
 Now that will get foamed when the glued hardens.

No comments:

Post a Comment