Stern light mount finished but for wiring it up

Marked up stern light mount for rounding the corners.

Rounded corners with the jig saw and then sanded them.

Locating where to drill holes for the rail (dingy davit ) mounts.

Holes drilled being carefuller not to go all the way through. Short a couple screws but rail mounts are installed.

Located the spot for the light and drilled the hole through for the wire.

Back side.

Front side of stern light.

Now to wire it up and we will mount it.

The mount is wide enough to be mounted on the center of the dingy davits cross bar. 

There is a plate in the center that the rail mounts must miss, that's why the mount is a little long. It looks fine but it could be shorter if it were not for the plate.

And you wonder why the old stern light was giving us such a pain.