Debbie picked up some ¾” Starboard from San Diego Plastics.
This is going to be used for our new cockpit table.
MPD-717
Folding flush-mount table hinge
We order the hinges form Marine Parts Depot
When we get the hinges we will drop them and the table top off the C. S. Ferguson for him to router uo spots for the hinges and make the cuts for the two wings. Then we will re-fit and make a template for the top part of the binical and send it back for more and cutting.
We also need to fabricate the top bracket that holds the current table so it will go on the binical on the outside of the 1” supports instead of the inside and then fasten new hinges to it. This is the old “Yacht Specifies” binicla and the SS supports are further apart than the new Edison binicals.
Ahhh it is never done is it
No comments:
Post a Comment