Spare bronze prop washer and prop key made - 2020

We had the machine shop make up a spare bronze prop washer and a spare prop key.
Now we have a complete set of spares in case we should lose the prop as almost happened in Tenacatita.September 2020 - We are currently in Paradise Village Marina in Banderas Bay Mexico (by Puerto Vallarta)
on the propeller shaft in the boatyard.
The bronze washer works with these nuts or the cone "D" zinc setup below.
And the measurements are:
 .43
OD 1.7610
ID .8955


Thick .2870
Key is 
One side .3130
The other side .3125 so +\- .005 thousands
Length 1.9595 so say 1.97 or even 2"
We tried the key in the slot on the shaft and it was just a bit tight but it did slip in. A little nude may be needed.

No comments:

Post a Comment