Our rebuilt PSS Type A Shaft Seal did a bit of dripping on our way back to the marina. It will take a bit of adjusting. We thought it best to let it seat itself in and then adjust it more. That is compressing the rubber a bit more. The machine shop faced off the end to the stainless steel coller and the stainless steel collar. They also buffed up the collar to look like new.September 2020 - We are
currently in Paradise Village Marina in Banderas
Bay Mexico (by Puerto Vallarta)
Pulling off the old PSS Type A Shaft Seal.
Pulling off the old PSS Type A Shaft Seal.
Rebuilt PSS Type A Shaft Seal installed.
The shaft was pulled and the cutlass bearing was just fine so all is good there.
No comments:
Post a Comment