Debbie cut some more template out and we added the two pieces of fiber glass panels that we had previously cut out. This time we used the slow hardener.
Debbie then cut one piece of fiber glass to cover the whole front side and the whole starboard side at once. That is minus a couple inches on the bottom where it juts out. I helped epoxy this piece in. We also got a few more pieces around the top opening. Some places now have two layers of fiberglass. We are going for three.
The slow hardener tends to let the epoxy drain down into the bottom of the refer where it pools up. This is not a problem as it evens out the fiber glass. We added a piece to the inside top and it stayed up there just fine using the slow hardener.
No comments:
Post a Comment