Got some Spectra water maker cabinet soundproofing done - 2013

Middle of October - Paradise Village Marina in Puerto Vallarta Mexico

 I got the final coat of the five coats of satin varnish on the outside of this cabinet.
Debbie made patterns of the bulkheads and then took one section of engine insulation and cut it to fit behind the raw water filter for the Spectra water maker.
Debbie's spray booth!

 

Could not add any under filter because we could not get the wrench on the fitter if we did.
 
The hard part I think was getting the bolts back through the filter and the insulation to the inside of the settee.

 This will hopefully quiet this filter as it tended to rattle a little making noise.

No comments:

Post a Comment