You can see the IN hose with the red hose clamp protector on it
While in the bilge working we saw the labels for the IN and OUT on the original bilge pump. We had access to the hose we had made up for the IN to the pump from the bilge and so installed it. Just needed a shorting of the connector hose by cutting off a half inch or so and it went right on.
December 2011 - Currently At Marina Cortez Harbor Island, San Diego, CA
Attached to the pump.
Going into bilge area.
Another angle
Now we will order a flat ¾ inch 25’ hose to through out into the cock pit for the out. A wire up of the pump and we can test it for an emergency pump.
Also one foot needs a screw installed (hole drilled).
Getting close to getting this done.
No comments:
Post a Comment