Whale Gulper IC bilge Pump sensor switch setup - 2012

 Called Whale support  (1 802 367 1091) to find out how Whale Gulper IC Diaphragm Bilge Pump sensor is located on the pump bottom. It is 2 /34 inches and will pump water to ¾ inches before it starts getting too much air.
 August 2012 - Currently at Marina Kona Kai  Shelter Island San Diego, CA  

 It has a 35 sec delay so it can pump the last of the water out. But if there is 2 ¼ inches of water in the bilge the pump will never go off. So we will have a manual over ride switch we can turn on and pump out the water down to the ¾ inch level.

 This means we will change our mind again and go with the normal bilge pump switch hat you can force on.

 We will use the other toggle switch for the wash down pump.
We plugged the old 1/2 through hull valve and this gave us some room to work. There was a hose and another valve and fittings sitting on top of this valve taking up a lot of room. This 1/2 through hull is just too small to use for anything so far. Possibly a sink salt water faucet?

Got some wiring done and ran the wires to the nav station.

Drilled the wholes for the switch , hose and wire.

We decided to move the Mermaid Marine Air 12000 btu March LC-3CP-MD pump and new 1\2" through hull to a different location if possible because of lack of room here.