2010 - Marina Cortez San Diego, CA
Debbie is screw on the car. She sure is a cutie working up there!
We put our end blocks on the traveler. We had to drill a 27/64 hole in the track. Took several smaller drills first. I had to borrow a ½ drill for the 27/64 drill bit. All went well.
We are now working on the line.
We were going to have the line spliced as my splicing is ok but not a nice tapered splice. Any way the splice world stop the car too short of the end block so we are getting the line sewed. This will give us good performance on the traveler with the car. It is being done by Ullman Sails . I just ran it across the street from Sailing Supply
Drilling hole for end stop
Drilling hole for end stop port
Drilling pilot hole for end stop starboard
Screwing in end stop
Drilling hole for end stop
Hole for end stop
Screwing in end stops
Drilled and taped holes for end stops
No comments:
Post a Comment