Spectra Ventura 200T water maker work - bolted three sections together - 2021

 It has been a while but we again did some more work on the Spectra Ventura 200T water maker. 
October 2021 - House sitting in Sothern Cal.

 We installed some "O" rings and separator and then bolted together two ends to the middle which has the "Annular Rings" which we replace earlier. Then we were going to finish off with bolting that section to the middle of the "Clark Pump" however we found we are missing a few parts to one of the four check valves. We ordered those parts. 
 The weather here in Sothern California, is still great and the weather in Puerto Vallarta and South will break early this year!
We did try to check our work with the home owners air compressor but we did not seem to get it right. We called tech support and they had never heard of that procedure so we decided to skip that quality control step.

No comments:

Post a Comment